Auto-Level Disabled When Printing From USB
 
Notifications
Clear all

Auto-Level Disabled When Printing From USB  

Strona 2 / 2
  RSS
Nicolas
(@nicolas-6)
Eminent Member
Re: Auto-Level Disabled When Printing From USB

I'm really surprised by this (the auto level disabled on USB mode).
I was pretty sure I already see the Z axis moving on USB.

Can someone confirm this behavior and the G87 fix ?

I'll try to pay attention next print.

Ps : I'm using octoprint all the time.

Opublikowany : 28/06/2016 3:00 pm
PJR
 PJR
(@pjr)
Antient Member Moderator
Re: Auto-Level Disabled When Printing From USB

Yeah, it works for me without the G87 code via OctoPrint.

Peter

Please note: I do not have any affiliation with Prusa Research. Any advices given are offered in good faith. It is your responsibility to ensure that by following my advice you do not suffer or cause injury, damage…

Opublikowany : 28/06/2016 5:03 pm
Nicolas
(@nicolas-6)
Eminent Member
Re: Auto-Level Disabled When Printing From USB

Just started a print and Z axis is definitively moving.
here is my firt gcode lines :

G90
M83
M106 S0
M140 S55
M190 S55
M104 S210 T0
M109 S210 T0
G28
G92 E0.0
G1 X60.0 E9.0 F1000.0
G1 X100.0 E12.5 F1000.0
G92 E0.0
G1 E-1.0000 F2100
G1 Z0.300 F1002

Opublikowany : 28/06/2016 6:30 pm
Jonathan
(@jonathan-13)
New Member
Re: Auto-Level Disabled When Printing From USB

I am pretty sure G87 only needs to be called once because it writes 0x01 into the non volatile eeprom. I don't see anywhere else that writes to that eeprom reg except G86 which disables mesh after homing.

Opublikowany : 29/06/2016 1:54 am
Strona 2 / 2
Share: