After auto leveling, still not level
 
Notifications
Clear all

After auto leveling, still not level  

  RSS
SpongyBob
(@spongybob)
Active Member
After auto leveling, still not level

When printing larger prints, the printer goes through it's normal auto leveling and when it goes to print the single layer skirt around the model print area it is visually obvious that at the front part of the print bed the layer height is a little flattened and at the back of the print bed it is a little round. Is this a problem with the auto leveling, the P.I.N.D.A probe, or something mechanical in the Y-axis? Any thoughts on where to look first?

Publié : 27/03/2018 6:03 pm
Partager :