Notifiche
Cancella tutti

ABS  

  RSS
david.s30
(@david-s30)
Active Member
ABS

I just purchased a spool of ABS, does anyone have a collection of tips, links, etc for printing ABS. I tried printing a little figure and it stringed up. If you have any good links, tips or vids, I would appreciate it.

Postato : 06/04/2017 12:58 am
Starlynk
(@starlynk)
Trusted Member
Re: ABS

I use eSun ABS+ and haven't had any problems. Only thing I can think of if its not adhering is you need to adjust your first layer calibration and make sure you use at least 91% Isopropyl alcohol or acetone as some have suggested.

Postato : 07/04/2017 5:48 am
Condividi: