Polycarbonate on MMU (Single extruder)

Dernier message

RSS

AJS

(@ajs)

Noble Member

Polycarbonate on MMU (Single extruder)

Just successfully printed polycarbonate (PC) on my MMU (single). Default settings do not work well. The settings in metacollin's thread do work well with modifications for MMU:

https://shop.prusa3d.com/forum/print-tips-slic3r-settings-kisslicer-model-repair--f12/polycarbonate-here-s-how-to-print-it-without-warpi-t6919.html#p58020

This stuff is very strong, and much more temperature tolerant.

Any advices given are offered in good faith. It is your responsibility to ensure that by following my advice you do not suffer or cause injury, damage or loss. If you solve your problem, please post the solution…

Publié : 03/01/2018 5:34 am

Statistiques du forum

559 Forums

62.9 K Sujets

442.9 K Messages

18 En-ligne

67.7 K Membres

Le dernier des messages: Leak at nozzle Notre nouveau membre: pinklemonade Messages récents Messages non lus Balises

Icones du forum: Le forum ne contient pas de messages non lus Le forum contient des messages non lus

Icones du sujet: Sans réponse Repondu Actifs Au top Épinglé Non approuvé Résolu Privé Fermé