How do you print selective soluble supports?
Anyone know how to slice the selective soluble supports Mr. Prusa was showing off in one of the updates.
Re: How do you print selective soluble supports?
Print Settings/Multiple Extruders
Set Support Material to a regular filament and interface extruder to the PVA extruder.
Peter
Please note: I do not have any affiliation with Prusa Research. Any advices given are offered in good faith. It is your responsibility to ensure that by following my advice you do not suffer or cause injury, damage…
Re: How do you print selective soluble supports?
Printing selective supports (soluble interface, non-soluble base) is not supported yet as there is a single XY gap applied for both, but a different value is needed for the selective support: Nearly zero XY gap for soluble interfaces and the usual gap for the non-soluble base. As of now you need to set the XY separation to the value normally used for non-soluble support.
Re: How do you print selective soluble supports?
Incorrect info
Please note: I do not have any affiliation with Prusa Research. Any advices given are offered in good faith. It is your responsibility to ensure that by following my advice you do not suffer or cause injury, damage…