Notifications
Clear all

Extruder calibration  

  RSS
richard.l
(@richard-l)
Member Moderator
Extruder calibration

Has anyone else felt the need to calibrate the extruders for the MM upgrade? I have 3 that look pretty good but 1 that is just terrible.

Opublikowany : 01/06/2017 6:56 pm
PJR
 PJR
(@pjr)
Antient Member Moderator
Re: Extruder calibration

Richard

All my 4 are spot on at 140 steps/mm. I believe that was the same for the other testers.

Peter

Please note: I do not have any affiliation with Prusa Research. Any advices given are offered in good faith. It is your responsibility to ensure that by following my advice you do not suffer or cause injury, damage…

Opublikowany : 01/06/2017 7:11 pm
Share: