Notifications
Clear all
Extruder calibration
Has anyone else felt the need to calibrate the extruders for the MM upgrade? I have 3 that look pretty good but 1 that is just terrible.
Napsal : 01/06/2017 6:56 pm
Re: Extruder calibration
Richard
All my 4 are spot on at 140 steps/mm. I believe that was the same for the other testers.
Peter
Please note: I do not have any affiliation with Prusa Research. Any advices given are offered in good faith. It is your responsibility to ensure that by following my advice you do not suffer or cause injury, damage…
Napsal : 01/06/2017 7:11 pm