Clear all

new to printing, not sure how to fix issues  

New Member
new to printing, not sure how to fix issues

I just started printing for the first time, and I am having some issues with a few prints (not all just these ones).

My friend sold me his mk2. after transporting it to my place I did a Z adjustment. I used PrusaControl to slice the model. These were both printed at 0.15 with support set to "everywhere". I used the default temps for PLA (210/55) and i turned down the speed to 80%.

I'm really new to this so I don't know where to start troubleshooting this. Does anyone have any suggestions on what I might be doing wrong or how to fix this? Thanks!

Posted : 02/04/2018 6:31 am
Reputable Member
Re: new to printing, not sure how to fix issues

You only need support if you have an overhang that is around 45 degrees and more.

Try your print without support first.

Tagaytay City, Philippines
Founder member of Philippines Prusa Printer Owners FB Group
Sponsor Pillars of God Academy in Bacoor

Posted : 02/04/2018 3:09 pm