Unable to install Firmware on Einsy Rambo 1.2b - freeze after upload
 
Notifiche
Cancella tutti

Unable to install Firmware on Einsy Rambo 1.2b - freeze after upload  

  RSS
revori
(@revori)
New Member
Unable to install Firmware on Einsy Rambo 1.2b - freeze after upload

Hallo,

I'm currently trying to set up a i3 MK2 with a Genuine Einsy Rambo 1.2b by Ultimachine. ( https://reprap.org/wiki/EinsyRambo)

I installed Arduino, the Rambo drivers and add-on. But every time I try to upload the firmware onto the board the LCD Screen freezes while displaying "Upgrading Firmware: Don't disconnect".

I also tried various Motherboard definitions in the configuration.h and Prusa as well as Marlin firmware.

Does anyone already encountered an error of this sort?

Postato : 27/08/2020 2:38 pm
revori
(@revori)
New Member
Topic starter answered:
RE: Unable to install Firmware on Einsy Rambo 1.2b - freeze after upload

Postato : 27/08/2020 2:46 pm
cwbullet
(@cwbullet)
Utenti
RE: Unable to install Firmware on Einsy Rambo 1.2b - freeze after upload

Did you get this to work?

--------------------
Chuck H
3D Printer Review Blog

Postato : 23/01/2022 6:52 pm
Condividi: