Notifications
Clear all
Unable to install Firmware on Einsy Rambo 1.2b - freeze after upload
Hallo,
I'm currently trying to set up a i3 MK2 with a Genuine Einsy Rambo 1.2b by Ultimachine. ( https://reprap.org/wiki/EinsyRambo)
I installed Arduino, the Rambo drivers and add-on. But every time I try to upload the firmware onto the board the LCD Screen freezes while displaying "Upgrading Firmware: Don't disconnect".
I also tried various Motherboard definitions in the configuration.h and Prusa as well as Marlin firmware.
Does anyone already encountered an error of this sort?
Napsal : 27/08/2020 2:38 pm
Topic starter
answered:
RE: Unable to install Firmware on Einsy Rambo 1.2b - freeze after upload
Napsal : 27/08/2020 2:46 pm
RE: Unable to install Firmware on Einsy Rambo 1.2b - freeze after upload
Did you get this to work?
--------------------
Chuck H
3D Printer Review Blog
Napsal : 23/01/2022 6:52 pm