Notifiche
Cancella tutti
Problem with Z level adjustment.
Hi,
After a few years of good working (mk2), I have a problem with Z level adjustment.
If I turn on my printer I always have information about tunning Z level. Printer remember last value of this parameter, but the nozzle is far from the bed.
Changing of firmware doesn't nothing change 🙁
Somebody had this issue?
Thanks!
Questa discussione è stata modificata 3 years fa 6 tempo da jszewczyk
Best Regards, Jacek
Postato : 17/07/2021 3:06 pm
.
Not sure, just trying to guess here.
Have you checked if the plastic parts of the extruder are in good shape? (expecially the one with the PINDA support).
I once had such part severely skewed due to the heat (many ABS prints can affect the PETG parts)
I'm not an expert. Ma parlo anche italiano 😉
Postato : 17/07/2021 3:59 pm