Polski
Fora
English forum
Original Prusa i3 MK2/S
Hardware, firmware and software help
Bed leveling once again and again
 
Notifications
Clear all

Bed leveling once again and again  

    Ostatni Post
  RSS
yoann.w
 yoann.w
(@yoann-w)
New Member
Bed leveling once again and again

Hi there,

I've been printing small objects since a long time without any problems, and today I'm printing lots of small objects in one time and found that bed leveling isn't working very well as pictures tell.

Is there a way to correct this ?
I'm running FW 3.0.12 on MK2s

Thanks

Opublikowany : 12/05/2018 10:58 am
PJR
 PJR
(@pjr)
Antient Member Moderator
Re: Bed leveling once again and again

The menu has a "Bed Level Correction" option (I think under "Calibration").

If that doesn't help, search the forum for "Hyperfine bed leveling"

Peter

Please note: I do not have any affiliation with Prusa Research. Any advices given are offered in good faith. It is your responsibility to ensure that by following my advice you do not suffer or cause injury, damage…

Opublikowany : 12/05/2018 11:02 am
yoann.w
 yoann.w
(@yoann-w)
New Member
Topic starter answered:
Re: Bed leveling once again and again

thanks I will search for that

Opublikowany : 12/05/2018 3:30 pm
  All forum topics
  Previous Topic
Next Topic  
Share: