Notifications
Clear all
Bed leveling once again and again
Hi there,
I've been printing small objects since a long time without any problems, and today I'm printing lots of small objects in one time and found that bed leveling isn't working very well as pictures tell.
Is there a way to correct this ?
I'm running FW 3.0.12 on MK2s
Thanks
Napsal : 12/05/2018 10:58 am
Re: Bed leveling once again and again
The menu has a "Bed Level Correction" option (I think under "Calibration").
If that doesn't help, search the forum for "Hyperfine bed leveling"
Peter
Please note: I do not have any affiliation with Prusa Research. Any advices given are offered in good faith. It is your responsibility to ensure that by following my advice you do not suffer or cause injury, damage…
Napsal : 12/05/2018 11:02 am
Topic starter
answered:
Re: Bed leveling once again and again
thanks I will search for that
Napsal : 12/05/2018 3:30 pm