Benachrichtigungen
Alles löschen
XYZ Calibration failed despite everything working fine.
I have a Prusa MK2.5 for many years. Until now without any problems.some months ago, the nozzle was about 2mm above bed level. So I had to recalibrate the printer. So the desaster began: always: xyz calibration failed. I have changed the pinda probe, I have now a deviation of the bed of 0,03°, in z-direction 0,1mm.All 4 points were found, but in the end...Despite all my trials, always the same error "XYZ Calibration Failed, Please Consult Manual" .Is it possible to get information about the algorithm of the calibration? That would be very helpful, any further tips, what can be done, would be appreciated.
Veröffentlicht : 03/08/2023 11:01 am
Girl on the Rocks gefällt das