Notifications
Clear all
MK3 USB Dead
Hello all,
I've been printing from Octoprint on a Raspberry PI 3 for many months now with no issues. I upgraded to the latest firmware (3.5.2) this past weekend and now the USB port seems to be completely dead. I cannot connect to flash an older firmware. I've submitted an email to support but have yet to hear back. Any advice for troubleshooting?
Thanks!
Charlie
Opublikowany : 20/02/2019 3:42 am
Re: MK3 USB Dead
have you tried a full factory reset after the upgrade?
Opublikowany : 20/02/2019 4:00 am
Topic starter
answered:
Re: MK3 USB Dead
have you tried a full factory reset after the upgrade?
Good point; I have not. I'll be trying that next.
Opublikowany : 20/02/2019 5:46 pm