MK3 USB Dead

Dernier message

RSS

cgrums

(@cgrums)

Active Member

MK3 USB Dead

Hello all,

I've been printing from Octoprint on a Raspberry PI 3 for many months now with no issues. I upgraded to the latest firmware (3.5.2) this past weekend and now the USB port seems to be completely dead. I cannot connect to flash an older firmware. I've submitted an email to support but have yet to hear back. Any advice for troubleshooting?

Thanks!
Charlie

Publié : 20/02/2019 3:42 am

vintagepc

(@vintagepc)

Membre

Re: MK3 USB Dead

have you tried a full factory reset after the upgrade?

Publié : 20/02/2019 4:00 am

cgrums

(@cgrums)

Active Member

Topic starter answered:

Re: MK3 USB Dead

have you tried a full factory reset after the upgrade?

Good point; I have not. I'll be trying that next.

Publié : 20/02/2019 5:46 pm

Statistiques du forum

559 Forums

63 K Sujets

443.6 K Messages

23 En-ligne

68 K Membres

Le dernier des messages: XL USB C Camera from the CORE Notre nouveau membre: etiennep Messages récents Messages non lus Balises

Icones du forum: Le forum ne contient pas de messages non lus Le forum contient des messages non lus

Icones du sujet: Sans réponse Repondu Actifs Au top Épinglé Non approuvé Résolu Privé Fermé