Mk2s with Mk2.5s bed to print the rest of the upgrade parts
I've been working on the Mk2s to Mk2.5s upgrade over the last few months. The parts I printed out didn't work for the upgrade so I thought to install the upgraded printbed and a new hotend so I can print out the upgrade parts (the original bed from the used Mk2s I bought was unusable). When I tried to do the XYZ config, it failed every time. I'm thinking it has something to do with the magnets in the new printbed not working with the Mk2 PINDA and Mk2 Firmware.
Any suggestions on how to proceed? I'm able to run prints now but the Z offset is all over the place when it does the auto bed leveling.
RE: Mk2s with Mk2.5s bed to print the rest of the upgrade parts
I'm also considering a Bear frame upgrade in the future if I can get this thing to actually function well. I have a Prusa XL on pre-order so right now I'm just wanting a printer to hold me over until my XL makes it here, then this will just be a basic PLA printer for smaller prints. That don't need the XL's tool changer or volume.