Français
Forums
English forum
Original Prusa i3 MK2.5 & MK2.5S
General discussion, announcements and releases
Mk2.5s first layer consistency issue
 
Notifications
Clear all

Mk2.5s first layer consistency issue  

    Dernier message
  RSS
josh.h7
 josh.h7
(@josh-h7)
Active Member
Mk2.5s first layer consistency issue

Please help, i habe these random points ok the first layer where it does not stick! Nozzle is clean, bed is clean, z is calibrated, z height is perfect on the rest of the print.

Publié : 25/04/2020 7:08 am
  Tous les sujets du forum
  Sujet précédent
Sujet suivant  
Sujets liés
Balises du sujet:  first layer (384), first layer not sticking (26), first layer calibration (104),
Partager :