Notifications
Clear all

X-Axis Problem, Layer shifting  

  RSS
docsascha
(@docsascha)
Active Member
X-Axis Problem, Layer shifting

Dear All

Had no problems with my MK2.5 Upgrade and done a few hours of printing, but no bigger projects over the last week or so (always 1 piece each)

However today I started printing a multipiece project and the layers within the first 0,5cm where not printed correct. There was a shift in x-Axis (picture). Afterwards there was no shifting, print looked OK

Printed a testfile consisting of 4 10x10x10 mm Cubes, placed on each corner of the printbed, and again layershifts in x-axis happend.

What can be the problem?

Sascha

Publié : 29/09/2018 5:03 pm
Partager :