Benachrichtigungen
Alles löschen
X-Axis Problem, Layer shifting
Dear All
Had no problems with my MK2.5 Upgrade and done a few hours of printing, but no bigger projects over the last week or so (always 1 piece each)
However today I started printing a multipiece project and the layers within the first 0,5cm where not printed correct. There was a shift in x-Axis (picture). Afterwards there was no shifting, print looked OK
Printed a testfile consisting of 4 10x10x10 mm Cubes, placed on each corner of the printbed, and again layershifts in x-axis happend.
What can be the problem?
Sascha
Veröffentlicht : 29/09/2018 5:03 pm