What am I seeing here?
I am having this problem with feathering on the side of each layer on the first layer. Does anyone have any ideas what is causing it? I am thinkng that the top issue might be bed contamination and the bottom one is that I still have the nozzle too low but I'm not sure?
RE: What am I seeing here?
Hi. Adjust your Live-Z. Your nozzle is too close to the sheet on the first layer.
Often linked posts:
Going small with MMU2
Real Multi Material
My prints on Instagram
RE: What am I seeing here?
@nikolai-r
Ok, I have gone up from -1.700 to -1.610 and it looks like that. Is it still too low?
RE: What am I seeing here?
Looks already pretty nice. You can try to raise a little bit more. From now on it's more a personal preference.
Often linked posts:
Going small with MMU2
Real Multi Material
My prints on Instagram
RE: What am I seeing here?
@ssmith
maybe you will find helpful information here:
Statt zu klagen, dass wir nicht alles haben, was wir wollen, sollten wir lieber dankbar sein, dass wir nicht alles bekommen, was wir verdienen.