Notifiche
Cancella tutti
Ugly walls, indents, and possible underextrusion?
I've been printing a helmet in multiple parts for a friend and I'm getting these consistently bad walls and thin, almost skipped layers at times. I ran all the tuning and made sure the rails and rods were greased and I seem to be getting uglier prints as they get taller.
I don't have it running at high speeds as listed and I'm using Elegoo PLA+ at 210-215 degrees which has been a great filament for me before. Is it the layer height that could be causing this?
Postato : 27/09/2023 12:42 am