Notifications
Clear all
Closeups of side filament sensor board?
Hey All
Have a bit of an odd request, could anyone with a Prusa XL please share some close up photos of the side filament sensor board?
Reason for asking is that I want to place the printer on an existing shelf, but the side filament sensors stick out enough to be an issue. So I want to relocate these to the rear of the printer, and to do this I need to know what my custom side filament sensor board will need to have
What I know so far:
- Connector is from the Molex CLIK-Mate 502585 family (likely 5025850570)
- Inside are 3 hall-effect sensors, same ones that are used on the MK4
This topic was modified před 2 years by ANTALIFE
www.antalife.com
Napsal : 25/05/2023 12:07 pm