Clear all

Closeups of side filament sensor board?  

Trusted Member
Closeups of side filament sensor board?

Hey All

Have a bit of an odd request, could anyone with a Prusa XL please share some close up photos of the side filament sensor board?

Reason for asking is that I want to place the printer on an existing shelf, but the side filament sensors stick out enough to be an issue. So I want to relocate these to the rear of the printer, and to do this I need to know what my custom side filament sensor board will need to have


What I know so far:

  • Connector is from the Molex CLIK-Mate 502585 family (likely 5025850570)
  • Inside are 3 hall-effect sensors, same ones that are used on the MK4
This topic was modified 6 months ago by ANTALIFE

Posted : 25/05/2023 12:07 pm