Notifications
Clear all
Black Collet / clips on left filament sensor
Hi there,
I've broken a few of the black collet / clips the PTFE tube goes into on the left filament sensor and need to get new ones. See picture below:
Are these the same as this part? https://www.prusa3d.com/en/product/heatsink-collet/
Opublikowany : 02/02/2024 1:41 am
RE: Black Collet / clips on left filament sensor
Yes, I'm almost certain that they are. Prusa actually calls it an "E3D Collet" on the parts bag that comes with the MMU3 (it uses several of these collets). You can also buy them from E3D direct.
Opublikowany : 02/02/2024 9:00 pm
Topic starter
answered:
RE: Black Collet / clips on left filament sensor
Awesome, thank you very much 🙂
Opublikowany : 02/02/2024 10:03 pm