Probe test speedup and tuning speed
Hi all, and sorry if answers already are here. Well first of all I´ve had MK3 for years and around 8km of filament there. I pre-ordered XL but that of cource took like 2 years to arrive. During time it arrived, had personal time changed not to be on printing that much. But did do some stuff, to see it works and liked what came out. Basicly after some time now, been back to mr XL . Previously used win10, now got to 11 so usual problems there, but now as he runs problem remains... Is it really so, XL takes this 10 min to probe, before anything happens?? Love my MK3 as when heated takes like minute to do some tiny bits? So question is, anyway to make XL more faster to start?? Something like 9 probe like MK3 does? Also when finally get it going, have you peeps made speed on it by tune? This again as I have 0.6 nozzle on my MK3, and there if have used 100% and goes fine. When doing like that I also use bigger heat like 230-240 for PLA etc, as filament is going wayyy faster. But comments on XL on this peeps?