Notifiche
Cancella tutti
Input Shaper frequency adjust as bed gains weight - removed from the slicer ?
In the previous system presets for MK4 (in PrusaSlicer), there was a command under "before layer change gcode", which gradually reduces frequency on Y axis as the print on the bed becomes heavier:
M593 Y T2 F{interpolate_table(extruded_weight_total, (0,40), (300,30), (800,20), (10000,20))}
Now (in the newest preset) this command is removed. Is it not needed, or does the new firmware (5.1.0) handle it by itself now?
Postato : 24/11/2023 2:26 pm