Notifications
Clear all
"Blob" at beginning of print
Lately all my prints are having an issue when starting extruding filament. There is a "blob" in the beginning, might be that the filament doesn't stick at once, see pictures. I've gone very low with the z-level (and also tried to go higher, but with basicly the same result.
Any suggestion?
Publié : 09/04/2021 11:19 pm
RE: "Blob" at beginning of print
Hi, your Z seems to be too high, re-run first layer calibration and go lower 🙂
Publié : 12/04/2021 10:24 am