Notifications
Clear all

Mini+ glitches during bed leveling  

  RSS
DaddyBoomalati
(@daddyboomalati)
Eminent Member
Mini+ glitches during bed leveling

The glitch (I apologize for the jumpy video, my cat Kiwi was in my lap). 

I have 2 Prusa Mini+’s and they both have this glitch probably 9/10 times during bed leveling. At some point during the leveling procedure, the x axis will only move about 2 mm before it probes again. The result is that it prints off center. I’ve tried reloading the firmware multiple times.

It may be note-worthy that I have a Bondtech Extruder and have the gcode for the e-steps saved as a custom printer in Prusaslicer.

I cannot find the hotend catching on anything when I move it back and forth by hand. 

Thanks,
Dave Smith

Posted : 26/08/2021 1:23 pm
fuchsr
(@fuchsr)
Famed Member

That sure doesn't look normal. And on two machines? Did you build them yourself? I guess I would get on the chat with Prusa Support and send them your video. Go to Prusa3d.com, log into your account, and go to the chat button in the lower right corner. 

Posted : 26/08/2021 1:47 pm
DaddyBoomalati
(@daddyboomalati)
Eminent Member
Topic starter answered:
Thanks!

Thanks! I built this one, but the other was factory-assembled.

Posted by: @fuchsr

That sure doesn't look normal. And on two machines? Did you build them yourself? I guess I would get on the chat with Prusa Support and send them your video. Go to Prusa3d.com, log into your account, and go to the chat button in the lower right corner. 

 

Thanks,
Dave Smith

Posted : 26/08/2021 5:59 pm
Share: