Mini+ filament sensor auto-off after booting; setting not saved
 
Benachrichtigungen
Alles löschen

Mini+ filament sensor auto-off after booting; setting not saved  

  RSS
flp
 flp
(@flp)
Mitglied
Mini+ filament sensor auto-off after booting; setting not saved

I have a Mini+ with firmware 4.4.1.

Filament sensor is installed, but I have to enable it manally at every printer start. It seems that the setting in the menu is not saved. After enabling it shows the correct state in the "Sensor" tab.

What is the issue here?

Veröffentlicht : 28/10/2023 2:16 am
shingdoh
(@shingdoh)
Active Member
RE: Mini+ filament sensor auto-off after booting; setting not saved

For me it was like that when i first got the printer, it never stayed on. After a factory reset it now stays on.

Veröffentlicht : 28/10/2023 10:36 am
Teilen: