Notifications
Clear all
Mini+ filament sensor auto-off after booting; setting not saved
I have a Mini+ with firmware 4.4.1.
Filament sensor is installed, but I have to enable it manally at every printer start. It seems that the setting in the menu is not saved. After enabling it shows the correct state in the "Sensor" tab.
What is the issue here?
Posted : 28/10/2023 2:16 am
RE: Mini+ filament sensor auto-off after booting; setting not saved
For me it was like that when i first got the printer, it never stayed on. After a factory reset it now stays on.
Posted : 28/10/2023 10:36 am