Mesh bed levelling error
Hi,
Can anybody please help with mesh bed levelling error? Each time it tries to take a probe the z-axis steps up a bit. Only location it can take, is the right side of the array. I made a small video.
https://photos.app.goo.gl/rnCvZZeN7Tv5snwA8
Prusa support asked to check the XZ calibration, it was fine.
Can the MINDA be defective?
RE: Mesh bed levelling error
Hi,
Can anybody please help with mesh bed levelling error? Each time it tries to take a probe the z-axis steps up a bit. Only location it can take, is the right side of the array. I made a small video.
https://photos.app.goo.gl/rnCvZZeN7Tv5snwA8
Prusa support asked to check the XZ calibration, it was fine.
Can the MINDA be defective?
I think that MINDA could be an issue. Your printer test much higher when doing the MESH leveling than mine.
--------------------
Chuck H
3D Printer Review Blog
RE: Mesh bed levelling error
Thanx Prusa, going to upgrade and see if it helps
RE: Mesh bed levelling error
Problem fixed, MINDA was broken!