English
Forums
English forum
Original Prusa MINI & MINI+
Hardware, firmware and software help
Mesh bed levelling error
 
Notifications
Clear all

Mesh bed levelling error  

    Last Post
  RSS
Riho
 Riho
(@riho)
Active Member
Mesh bed levelling error

Hi,

Can anybody please help with mesh bed levelling error? Each time it tries to take a probe the z-axis steps up a bit. Only location it can take, is the right side of the array. I made a small video.

https://photos.app.goo.gl/rnCvZZeN7Tv5snwA8

Prusa support asked to check the XZ calibration, it was fine.

 

Can the MINDA be defective?

Posted : 24/11/2020 12:39 pm
cwbullet
 cwbullet
(@cwbullet)
Member
RE: Mesh bed levelling error
Posted by: @riho

Hi,

Can anybody please help with mesh bed levelling error? Each time it tries to take a probe the z-axis steps up a bit. Only location it can take, is the right side of the array. I made a small video.

https://photos.app.goo.gl/rnCvZZeN7Tv5snwA8

Prusa support asked to check the XZ calibration, it was fine.

 

Can the MINDA be defective?

I think that MINDA could be an issue.  Your printer test much higher when doing the MESH leveling than mine.  

--------------------
Chuck H
3D Printer Review Blog

Posted : 24/11/2020 2:18 pm
Riho
 Riho
(@riho)
Active Member
Topic starter answered:
RE: Mesh bed levelling error

Thanx Prusa, going to upgrade and see if it helps

This post was modified 4 years ago by Riho
Posted : 02/12/2020 4:16 pm
Riho
 Riho
(@riho)
Active Member
Topic starter answered:
RE: Mesh bed levelling error

Problem fixed, MINDA was broken!

Posted : 02/12/2020 5:05 pm
  All forum topics
  Previous Topic
Next Topic  
Share: