Notifiche
Cancella tutti
Mac address Prusa Mini
Somehow my Prusa Mini does not show a MAC Address. It always shows: ff:ff:ff:ff:ff:ff
I've tried multiple firmware versions, but that does not seem to matter. Is there some way to assign a MAC Address?
Assigning a static ip works, but the prusa does not go online because of the missing MAC Address.
Questa discussione è stata modificata 4 years fa 2 tempo da ruben.schevers
Postato : 06/08/2020 7:12 pm
RE: Mac address Prusa Mini
I think the MAC address should be programmed to EEPROM when the Buddy board is first programmed by Prusa at the factory. I think you will need to contact support to get assistance.
Postato : 06/08/2020 10:15 pm