Avisos
Vaciar todo
Mac address Prusa Mini
Somehow my Prusa Mini does not show a MAC Address. It always shows: ff:ff:ff:ff:ff:ff
I've tried multiple firmware versions, but that does not seem to matter. Is there some way to assign a MAC Address?
Assigning a static ip works, but the prusa does not go online because of the missing MAC Address.
Este debate ha sido modificado el hace 4 years 2 veces por ruben.schevers
Respondido : 06/08/2020 7:12 pm
RE: Mac address Prusa Mini
I think the MAC address should be programmed to EEPROM when the Buddy board is first programmed by Prusa at the factory. I think you will need to contact support to get assistance.
Respondido : 06/08/2020 10:15 pm