Notifiche
Cancella tutti
Extreme Extrusion Multiplier Variations
Hello all,
I am running into this issue where I run an extrusion multiplier test (following this guide https://guides.bear-lab.com/Guide/Extrusion+multiplier+and+filament+diameter/8) on 5 of my minis. Every mini will get extreme variations in extrusion width on each side. Each one has similar thickness around: Front = .40, Right= .42, Back .47, Left= .45
My minis all have the bondtech upgrade. I am using the stock profiles with the addition of the added Gcode for the bondtech extruder upgrade.
This is with Jessie black PLA. Any help would be greatly appreciated!
Postato : 03/10/2020 10:11 pm