Notifications
Clear all

Extreme Extrusion Multiplier Variations  

  RSS
HamlinJacob
(@hamlinjacob)
New Member
Extreme Extrusion Multiplier Variations

Hello all,

I am running into this issue where I run an extrusion multiplier test (following this guide https://guides.bear-lab.com/Guide/Extrusion+multiplier+and+filament+diameter/8) on 5 of my minis. Every mini will get extreme variations in extrusion width on each side. Each one has similar thickness around: Front = .40, Right= .42, Back .47, Left= .45

My minis all have the bondtech upgrade. I am using the stock profiles with the addition of the added Gcode for the bondtech extruder upgrade.

This is with Jessie black PLA. Any help would be greatly appreciated! 

Posted : 03/10/2020 10:11 pm
Share: