Notifications
Clear all

Changing filament during print  

  RSS
Miro5law
(@miro5law)
New Member
Changing filament during print

I have installed filament sensor in my Mini Prusa. I tried to print LCD back cover and ended with 80%. My sensor has detected end of filament and I purged remaining 50 cm of filament. However when I tried to push/load new filament, it did not load into Extruder/ heatbed fully.

So when I resumed printing it started to print with no filement heated. I need to stop this print unfinished and run calibration mode.

Did anybody knows how to fix problem with filament not getting to the extruder at exact position. I did not set anything yet to adjust it.

Thank you in advanced.

Posted : 13/07/2020 7:24 pm
mark
 mark
(@mark)
Reputable Member
RE: Changing filament during print

See this thread:

https://forum.prusa3d.com/forum/how-do-i-print-this-printing-help/filament-change-mid-print/

It works very well for me now with firmware 4.1.0. It provides a "retry" button if the filament is not loaded correctly.

Regards,

Mark

Posted : 14/07/2020 1:04 am
Share: