Notifications
Clear all
Prusaslicer problem with retract_restart_extra_toolchange parameter
Hello,
First of all, I apologize if I do not post in the right forum.
I use Prusaslicer 2.9 (but it is the same with 2.8.1 version) with an Ender 5 where I installed a second extruder. So I don’t understand why there is no "retract restart extra toolchange" applied in the gcode file, when I have the following parameters in both extruders (extruder 1 and 2):
- retract_lenght_toolchange: 1
- retract_restart_extra_toolchange: 5
Thanks for you help
Publié : 16/01/2025 3:06 pm