Differences in the gcode from PrusaSlicer and Simplify3D
 
Avisos
Vaciar todo

Differences in the gcode from PrusaSlicer and Simplify3D  

  RSS
Steaming T
(@steaming-t)
Eminent Member
Differences in the gcode from PrusaSlicer and Simplify3D

I am using both PrusaSlicer and Simplify3D to slice my creations made in Fusion 360, although I am relying more and more on PrusaSlicer as time goes by. One thing S3D handles a little bit better is adding and removing support. But I have noticed that the resulting gcode-files from the two programs differs in two ways. When Gcode-files from PrusaSlicer is loaded into my Mini+, the screen shows a thumbnail of the actual item to print AND the estimated printing time. These two bits of info is completely lacking in the gcode-files from S3D. Does anybody know why?. Does PrusaSlicer add specific gcode commands in order to display a picture and how long the printing is going to last?

Respondido : 12/07/2022 1:26 pm
Neophyl
(@neophyl)
Illustrious Member
RE: Differences in the gcode from PrusaSlicer and Simplify3D

Simple answer is yes.  

Respondido : 12/07/2022 1:40 pm
Compartir: