Updating MK3 firmware via Prusa Connect

Dernier message

RSS

fibreking

(@fibreking)

Membre

Updating MK3 firmware via Prusa Connect

Can updating the MK3 firmware be done over Prusa Connect like the mk4/xl/buddy printers? Would be extremely helpful instead of having to plug a computer into the mk3s

Publié : 05/01/2024 12:50 am

nhand42

(@nhand42)

Trusted Member

RE: Updating MK3 firmware via Prusa Connect

Posted by: @fibreking

Can updating the MK3 firmware be done over Prusa Connect like the mk4/xl/buddy printers? Would be extremely helpful instead of having to plug a computer into the mk3s

There was a github request for this. The devs said no because there was too high a risk of bricking the printer.

https://github.com/prusa3d/Prusa-Link/issues/879

Publié : 05/01/2024 7:16 am

Tojik a aimé

Statistiques du forum

559 Forums

62.9 K Sujets

443 K Messages

20 En-ligne

67.7 K Membres

Le dernier des messages: What kind of fuse is on the modular bed board? Notre nouveau membre: pinklemonade Messages récents Messages non lus Balises

Icones du forum: Le forum ne contient pas de messages non lus Le forum contient des messages non lus

Icones du sujet: Sans réponse Repondu Actifs Au top Épinglé Non approuvé Résolu Privé Fermé