Notifications
Clear all

Very flat bed but nothing sticks in 2 corners  

  RSS
Andrew Pawelski
(@andrew-pawelski)
Trusted Member
Very flat bed but nothing sticks in 2 corners

I have a mini for nearly 2 years and it has never really printed well in the bottom right or top right corners.  I recently did the silicon bed mod and now have a beautifully flat bed .07 variance across it.

Yet a first layer calibration still demonstrates it wont stick in the same areas.

Yes clean surface with soap and 100% iso, no skew I can see on the axis

Z is low - i actually gradually went down to past what it should be and getting build up on the caibration square

Only way anythign sticks is using 1mm first layer extrusion width

can anyone suggest anything else to try?

Napsal : 07/07/2022 8:50 pm
Diem
 Diem
(@diem)
Illustrious Member

Please show us a picture of the issue.

Cheerio,

Napsal : 08/07/2022 7:16 am
Andrew Pawelski
(@andrew-pawelski)
Trusted Member
Topic starter answered:
RE: Very flat bed but nothing sticks in 2 corners

Here is my bed

Napsal : 08/07/2022 12:40 pm
Andrew Pawelski
(@andrew-pawelski)
Trusted Member
Topic starter answered:
RE: Very flat bed but nothing sticks in 2 corners


And here is part of a bed level test

yes the beds a bit dirty in this photo but same result when properly cleaned

 

Napsal : 08/07/2022 12:50 pm
Diem
 Diem
(@diem)
Illustrious Member

Er, thank you; that's not what I meant. Please show us the first layer calibration result.

Cheerio,

Napsal : 08/07/2022 12:54 pm
Chris Laudermilk
(@chris-laudermilk)
Estimable Member
RE: Very flat bed but nothing sticks in 2 corners

Is that the only plate you have? Same problem with other plates?

My other printer gave me fits with a couple of plates until I lightly sanded them with 600 grit sandpaper, then cleaned with soap & water. Now they work great. It's the nuclear option, but it is something to consider if all else fails.

Mini+ (kit) - Revo Micro | Antler Cooling | WiFi (4.4.0RC1)

Napsal : 08/07/2022 1:29 pm
oriddlero
(@oriddlero)
Eminent Member
RE: Very flat bed but nothing sticks in 2 corners

What material and what temperatures are you running? Fans?

If my post helps you please consider downloading & making one of my most popular Prusa-Printables 3D models below:1. Ultimate Printer Knob Upgrade - The Best Knob of Both Worlds 2. Prusa MK3S Right…

Napsal : 11/07/2022 11:22 pm
Share: