Top Layer Issues - Adaptive Cubic + 60% Infill
Having some top layer issues. I saw somewhere using an adaptive cubic helps with making a tighter bridge at the top of the print. Here are my setting and current print job with the mini. Super bummed these prints arent nice and clean at the top. Any suggestions?
RE: Top Layer Issues - Adaptive Cubic + 60% Infill
What are we looking at in the second picture? Is that a side view? If so, that looks bad.
Best way to get good advice here is to save the STL as 3mf project file from Prusaslicer, zip compress it and upload it here. That way we can see all your settings.
60% adaptive cubic should give a decent top surface.
Formerly known on this forum as @fuchsr -- until all hell broke loose with the forum software...
RE: Top Layer Issues - Adaptive Cubic + 60% Infill
@fuchsr
Thank you for your reply.
Yes the second image is a side view. 3mF file is included below.