Notifications
Clear all

Octoprint on Mini  

  RSS
Corfam
(@corfam)
Active Member
Octoprint on Mini

Has anyone confirmed that the Mini  is working with Octoprint?  I'm surprised that I haven't seen any comments...although I may have missed them.

Posted : 16/12/2019 2:09 am
padigree
(@padigree)
Trusted Member
RE: Octoprint on Mini

i think you've missed them.

https://forum.prusa3d.com/forum/user-mods-octoprint-enclosures-nozzles/when-will-we-have-octoprint-support/

 

there is also a Blog post, linked in the thread above.

 

Kind regards

This post was modified 4 years ago by padigree

It’s better to give than to receive. Especially advice.

Posted : 16/12/2019 12:59 pm
Corfam
(@corfam)
Active Member
Topic starter answered:
RE: Octoprint on Mini

@padigree

Thanks for pointing me to the other post!  I had completely missed it.

Got it.  No support yet.

Posted : 16/12/2019 1:55 pm
Corfam
(@corfam)
Active Member
Topic starter answered:
RE: Octoprint on Mini

Just following up here in case someone reads this thread down the line.  Sorry for my original post being in the wrong place.

It turns out that the MINI does support Octoprint when connected through the microUSB port (not the USB-A port) on the MINI.

https://forum.prusa3d.com/forum/user-mods-octoprint-enclosures-nozzles/when-will-we-have-octoprint-support/paged/2/

Posted : 22/12/2019 1:09 pm
Share: