Mini+ Prusa Enclosure?
I noticed on the MK3S+ Enclosure video there was mention of a Mini+ Enclosure in the works.
I tried searching around for information on it, but didn’t find anything.
Has anyone seen any information on an official Prusa Mini+ Enclosure?
RE: Mini+ Prusa Enclosure?
There hasn't been any mention of a Prusa Mini enclosure. With everything going on around the XL delays, I'd be stunned if they devoted ANY resources to anything like that.
RE: Mini+ Prusa Enclosure?
I'll bet the XL is the perfect size for a mini enclosure. 🤔
RE: Mini+ Prusa Enclosure?
Ah, I haven’t been keeping up with delays. The picture attached is a screenshot from their enclosure video that mentions it.
There hasn't been any mention of a Prusa Mini enclosure. With everything going on around the XL delays, I'd be stunned if they devoted ANY resources to anything like that.
RE: Mini+ Prusa Enclosure?
I just use a regular Lack v2 enclosure. Cheap piece of crap but does the job just fine.
RE: Mini+ Prusa Enclosure?
I put my two minis in two regular Prusa Enclosures. *shrug*
It fits plenty and nicely - even you can put Mini's spool holder in without any problem.
RE: Mini+ Prusa Enclosure?
Same here. Just went with the Lack enclosure for the MK3s. The buildguide is easy to follow and the Mini fits inside easily, even leaving room for tools, etc.
Prusa Mini FW4.4.1
RE: Mini+ Prusa Enclosure?
I picked up a Tukkari enclosure and I am a fan of it. Really cut down the noise of the printer and gives a good environment for printing ASA. It doesn't hurt that it looks nice too.