Bondtech BMG-M with Mosquito Hotend Mini Install
Hello All,
I am trying to assist my wife with the upgrades on her Prusa Mini 3D printer, and since she was having heat issues with her prints, it was suggested that she upgraded her hotend, which she did, but also purchased a Bondtech BMG-M extruder, and for the life of me, do not see a way to install it.
Is there a kit out there for this conversion, or is this not even possible?
I wired it, loomed it, and when I was about to install it, I asked my wife, "where are the other parts?"
LoL, she replied, "That's all it came with, and don't go making any additional upgrades"
So we have been going back and forth over this thing, and I just wanted to know if this upgrade were even possible on her Mini.
Thanks in advance!
RE: Bondtech BMG-M with Mosquito Hotend Mini Install
Anything is possible, but I would not install that upgrade. I am not sure you could do so without losing height.
--------------------
Chuck H
3D Printer Review Blog