Notifications
Clear all
12 months progress
I've had my Mini+ for just over a year now, and thought I'd share examples of 2 prints, done 12-months(ish) apart to show the difference between (bottom) a brand new user and printer, and (top) a beginner user and a maintained/bedded-in printer with properly dialed in settings:
(I haven't rebuilt a hot end or replaced a nozzle yet, so I still consider myself a beginner).
It wasn't until I looked at these side by side that I realised how much I've learned over the last year, and how utterly lost I would have been without you wonderful bunch on this forum!
Posted : 21/08/2022 10:48 am
RE: 12 months progress
How did you get rid of the wisps?
Posted : 22/08/2022 4:48 am
Topic starter
answered:
RE: 12 months progress
It's the cumulative effect of properly dialed-in flow rate settings, and filament that had been dried for 5 hours, I think.
Posted : 22/08/2022 12:58 pm