Notifications
Clear all
MMU3 how to print brim on raft
I am printing PC on a PETG raft with a MK4 and MMU3. This works well but sometimes sharp corners of the PC tend to lift off the raft and I am wondering whether there is a way to convince Prusaslicer have a PC brim on the PETG raft? I could explicitly add lily pads to the model in these corners but it would be so much simpler if I could just add a brim in the slicer.
If I tick 'Brim', the brim appears briefly on the screen but then goes away again.
Chris
Publié : 21/10/2024 7:11 am