mk4s lcd display

Dernier message

RSS

Happy

(@happy)

Active Member

mk4s lcd display

Received a new assembled MK4S mmu3 and lcd screen is very glitchy and goes blank at startup anyone else have this problem

Publié : 08/10/2024 1:52 pm

iftibashir

(@iftibashir)

Honorable Member

RE: mk4s lcd display

Ive had it glitch once, and restarted the printer. Havent seen it since TBH......

Click here for VIDEO BUILD GUIDES + 3D Printing Tips & Tricks!

--> MK4 - MK4S - MINI+ - Accelerometer Guide - BambuLab A1 Combo <--

Publié : 08/10/2024 2:03 pm

JP Guitars

(@jp-guitars)

Reputable Member

RE: mk4s lcd display

Check the cable from the control box to the back of the screen pcb is firmly in place at both ends

Publié : 08/10/2024 2:14 pm

Hesbas

(@hesbas)

Eminent Member

RE: mk4s lcd display

I had the same the first time I started a newly build printer. After a few restarts it was gone and did not came back. Using the printer for almost 30 day, daily. It is reliable now. Nevertheless is was a very unexplainable behaviour.

Publié : 08/10/2024 8:48 pm

hervel38

(@hervel38)

Membre

RE:

i have the same problem.

i ve check cable, connectique,lcd screen , with the prusa chat, and the solution (for the moment) was to reinstall the firmware with a good usb key

Publié : 20/10/2024 7:09 pm

Statistiques du forum

559 Forums

63 K Sujets

443.5 K Messages

21 En-ligne

67.9 K Membres

Le dernier des messages: Second layer does not make it like the first Notre nouveau membre: etiennep Messages récents Messages non lus Balises

Icones du forum: Le forum ne contient pas de messages non lus Le forum contient des messages non lus

Icones du sujet: Sans réponse Repondu Actifs Au top Épinglé Non approuvé Résolu Privé Fermé