Notifiche
Cancella tutti
Stringing issues after upgrading to MK4S
I built my MK4 back in April, and it was printing great, but then I upgraded to the MK4S and I think now that I'm using a high flow nozzle, it's causing a LOT of stringing issues that wasn't there before. Anyone got any good settings to help counter this? I printed a Temp Tower and it showed stringing on almost every layer. Hoping someone has seen this issue and found a fix for it?
Questa discussione è stata modificata 1 month fa da Gabriel Fricke
Postato : 02/12/2024 3:27 am
Denis Ferrari hanno apprezzato